Because it has low input impedance and high drive current. But almost all MOSFET drivers used totem pole output. There are many types of MOSFET drivers available in the market. MOSFET drivers are used to avoiding these issues. This problem is known as the miller effect. High voltage on the drain of MOSFET cause problem by interaction with gate-drain capacitance. One can do it very easily but there is one issue. Why we need a MOSFET driver? Because MOSFETs are voltage control devices and used to drive MOSFET the gate capacitance should be charged to operating voltage which is usually between 9-10 volt. How to use a MOSFET driver? MOSFET driver circuits are used to drive MOSFETS in a high side or low side. It can drive both low side and high side switches in half-bridge and low bridge circuits. Finally a wire is soldered next to the gate leg of the MOSFET and connected to it, this wire is the wire that will go to the pin on your micro-controller that will communicate with the transistor.IR2110 is a high voltage MOSFET driver IC. A wire is soldered next to the source leg of the transistor and connected to it, this will be your ground connection.

Another wire is soldered in place next to this and connected to the prior connection, this will be what is normally the ground side of whatever your device is. The diode is soldered in place and the excess is trimmed off and the middle leg and the schottky diode are connected. Next I install the transistor on the board so that the middle leg (drain) is aligned with the un-soldered end of the schottky diode. Then I bend the two ends of the schottky diode down and insert it into the board with the banded end away from the mosfet and then bridge the connection between it and the other power wires. After that I insert the wire that will be for power to my device I also bridge the connection between these two on the circuit board. Insert the wire into the board and solder. Here there is ample room for what I plan on wiring. Placement is something that is important if your wiring several things to your circuit board.

First I strip the wire that will provide the power to the circuit.

Wiring this is relatively simple but for anyone who is just starting out I'll go through every step.

Download free mosfet pinout